Mounting Crybaby and Boss pedals

Holispirit

New member
Hi guys,
just wanted to ask for everyone's opinion regarding this issue. For crybaby pedals, there are usually rubber feet attached at the bottom. When I removed them and was about to stick velcro on it, I realised that there are screws which protrude out and makes it hard to stick velcro on it.
As for Boss, their pedals, their pedals have rubber sticked underneath. Am I suppose to remove this as well in order to stick velcro?
Anyone care to share their experiences on this matter??
Many thanks again :)
 
I don't have a wah on my board, sorry no ideas. But i do have a BOSS Line Selector and DS-1, so that's what i do for them. I keep the rubber legs in case i wanna sell them next time, unlikely though.
 
the rubber feet and the screw should be able to separate. If not, just find countersunk or flat head screw of similar size to the wah original rubber feet screw, replaced it.

Even if the countersuck or flatheard screw protrude out a bit, the velcro should stick around the rest of the baseplae. And if getting this kinda velcro below, which is strong, confirmed very stronger than bushy velcro, even with slight screws protrude out, its not a problem at all.

a6.jpg


Anyway, even if having to bring out the pedalboard every week for jamming or show, having a wah pedal thats not secured to the pedalboard is prolly a small small issue. Just a matter of habitual change in transporting.

Heh, if dont even bring out the pedalboard on regular basis, then perhaps the velcro part is not even an issue.
 
Back
Top