My DIY edrums

indahreno

New member
My DIY drums

i'm newie here.. wanna share my journey to build a diy edrum..

the 1st phase/trial
- brain - winpdrums
- using contact triggered (so many miss-shot)
- aluminum mesh for pads (low noise, but overstringed will increase miss-shot)
- footswitch-like pedal (so far ok, oso if double)

the pics
Image000.jpg


the trial

http://www.youtube.com/watch?v=WWcCohPQpIohttp://www.youtube.com/v/WWcCohPQpIo&hl=en_US&fs=1&rel=0
 
Last edited:
solving missing shots problem

as in my post#1, i'v assemble all the drums since i tested the shots response on a single mesh pad.. assembled on the rack, the missing shot happen especially when rolling.. (it didn't happen on cymbals)
so i test it again (single, not on the rack), the miss shot didn't happen..
i guess i'v to built stiffer rack (current rack all using 1/2" un-glued pvc pipe CLASS D.. lol)
then' i'v also differs each stick input, & its gave more accurate shot (i think, since i'm totally zero with drums playing) as in this utube link

http://www.youtube.com/watch?v=IutX7GIZmdQ
 
too lazy to move on with the edrum thing, i'v try to build acoustic shell using 2mm bendwood.. for the time being i only successfully built a fullset of a 13" x 6" snare using;
uno by evans top + bottom
tama starclassic snappy w/o throw of
snare.JPG

snare1.JPG

snare2.JPG

dunno how to describe the sound (noob), perhaps i'll put in utube for your comments

12" tom in the making..
Image003.jpg


actually, i plan to built drums like TRAPS (narrow shell ~2") but i wanna put resos at the bottom of it.. bcos i wanna a lower volume set since my pearl xport set too loud that i can't play after 10pm.. I'm also have pearl RT, works fine.. but still to loud,... hopefully i wanna set that i can play after 2PM .. :P

about the traps-like shell, mayb i hav to put more vent.. or is there any suggestions
 
Back
Top