Cubase Sx/MoPhatt Module/Keyboard ...HELP PLZ!!

[Yungw1]

Ok, Firstly setup: Iv got my Module In/out connected to my Keyboard and my USB port on the keyboard connected to the harddrive of my computer..
I managed to Play my Keyboard on Cubase Sx but only using the Cubase Preset Sounds..I may even be mixing the 2, the Cubase preset sounds AND the Module Sounds(if that makes any sense)..How do I NOT use the Cubase Sounds and ONLY use the Sound Module Sounds??is thea something i need to do on Cubase that i am not doing? Also, how do you control your Module using the Keyboard..Please help

 

[lowjk]

>> Iv got my Module In/out connected to my Keyboard and my USB port on the keyboard connected to the harddrive of my computer..

1) The USB cable from your keyboard should NOT be plugged into the harddrive. Unplug it now and plug it into the USB port of your computer.

If you're keyboard usb connection is class-compliant, you're good to go. If not, please install the drivers according to the instructions (may need to disconnect keyboard while driver is being installed).

Also make sure that you have connected the midi cables correctly between your keyboard and Mo Phatt.

>> I managed to Play my Keyboard on Cubase Sx but only using the Cubase Preset Sounds..

2) Ensure that your Emu Mo Phatt audio out is connected to the computer, either directly or indirectly using an audio mixer.

Then run Cubase, and select a new 16 channel MIDI project. Under the track inspector, ensure that you see "all midi inputs" is highlighted under midi input.

Below that is the midi output. Make sure that your keyboard is selected (since you are using that as a midi interface). For testing, select "any" as the midi output channel. Turn down the volume on the keyboard if applicable. Turn up the Mo Phatt volume.

Play some notes. Mo Phatt should sound.

After establishing that the connections are all okay, select the midi channel that your Mo Phatt is on in Cubase (to avoid confusion later when you add more sound layers).

>> I may even be mixing the 2, the Cubase preset sounds AND the Module Sounds(if that makes any sense)..

Not possible unless you specifically set it up that way in Cubase. Cubase preset sounds should be under ASIO inputs and Mo Phatt sounds should be under Audio inputs in your computer software mixer.