shinobi
New member
hi guys i need some mods to be done on my fender jazz bass.
1. pickup installation
i have a set of hum-cancelling jazz bass pickups to install.
2. routing of the jazz bass control cavity
as i'm using a j-retro preamp, i would like to make the control cavity about 5mm deeper so that it will be easier to swap the battery, and i won't risk putting any of the electronics under pressure.
3. shielding
since the control cavity is currently shielded with copper tape, routing the cavity in (2) will remove the shielding. so if that happens i wanna redo the shielding.
hope you guys can give me an itemised quote and the estimated turnaround time for this job... depending on my band's schedule and my budget, i may decide not to do the routing and shielding for now.
my number is 8128-3057 drop me an sms, may be busy at work.
thanks!
1. pickup installation
i have a set of hum-cancelling jazz bass pickups to install.
2. routing of the jazz bass control cavity
as i'm using a j-retro preamp, i would like to make the control cavity about 5mm deeper so that it will be easier to swap the battery, and i won't risk putting any of the electronics under pressure.
3. shielding
since the control cavity is currently shielded with copper tape, routing the cavity in (2) will remove the shielding. so if that happens i wanna redo the shielding.
hope you guys can give me an itemised quote and the estimated turnaround time for this job... depending on my band's schedule and my budget, i may decide not to do the routing and shielding for now.
my number is 8128-3057 drop me an sms, may be busy at work.
thanks!
