locking tremolo arm?

[shuinx2]

hey guys i own a RG370DX, is there anyway to lock the tremolo arm so it will not look so loose

 

[XLayaR]

Wah I wanted to get the 370DXL.....Is it good?

Wind the arm deeper can liao

 

[kaiwenny]

ya spin spin spin about 1 or 2 rounds before cannot spin anymore.haha.good mah rg370dx?

 

[shuinx2]

yeah not bad lar... first time hoot such an expensive(my first investment) guitar.. but i think the hoot is worth.. bcoz it sound nice

 

[shuinx2]

Wah I wanted to get the 370DXL.....Is it good?

Wind the arm deeper can liao

wind deeper liao but still look quite loose... is it normal?

 

[XLayaR]

If it hangs downwards means its not tight enough lor.....Must make sure its screwed in properly

 

[shuinx2]

If it hangs downwards means its not tight enough lor.....Must make sure its screwed in properly

u mean there is way which it wun let it hang downwards? the manual only teach me how to wind deeper nia.. nv teach how to tighten

Edit: ok i saw the hole liao... LOL juz lift up the tremolo to see the hole...

 

[ShredCow]

RG370DX? That's with an Edge III trem right?

Since when was the Edge III trem arm a screw in arm?

There's 2 small holes at the back of the trem, directly behind the trem arm. There is a hex screw in each. Take a small allen key and tighten slightly. You might need to push the trem forward/down to see the lower hole - be careful.

 

[Marksman]

Continuing from what Shreddy said about the adjustment for the torque and stuff for the Edge 3, alternatively, you can do what i did: Tear a small piece of paper, height from the short side of the trem arm to before when the trem arm forms the angle, circumference according to your need (i use about 330 degrees arc), wrap around the short end of the arm, and put the trem arm together with the piece of paper. (You might catch no ball due to how I phrase it, but if you do, thats good)

 

[shuinx2]

Continuing from what Shreddy said about the adjustment for the torque and stuff for the Edge 3, alternatively, you can do what i did: Tear a small piece of paper, height from the short side of the trem arm to before when the trem arm forms the angle, circumference according to your need (i use about 330 degrees arc), wrap around the short end of the arm, and put the trem arm together with the piece of paper. (You might catch no ball due to how I phrase it, but if you do, thats good)

抓不到球T_T

 

[RyanZ]

What Marksman was trying to say is, tear a piece of paper, wrap it around the trem bar and insert into the trem hole. This is to increase the thickness of the trem bar to secure it better. I hope I implement it right.

 

[Marksman]

A cookie to Ryanz