Buzzing on the D and G string..Need help

[tuyulaneh]

My guitar returns after a proffesional setup, however, the string buzzes in the D and G string, from the first fret to the 16th fret. The other strings are fine, however every freted notes will buzz on these 2 strings..Any idea what happened here? My tech cant seem to find out the problem too.

Things that are done
-Truss rod adjustment
-refret of entire board with 6100 fret
-Action adjustment, no matter how high the action is, the D and G string will buzz!!!

Information on guitar
-The guitar is a floyd rose guitar.
-A tremol-no is already installed
-6100 frets
-16" radius
-ebony board


Thanks for any help

 

[naviros]

I believe you can adjust the action from the bridge as well, heighten it and its should be fine...

 

[tuyulaneh]

Did that..still buzzing all over the fret on the G string especially

 

[naviros]

Did that..still buzzing all over the fret on the G string especially

If its on one side only... Guess its neck warping but both sides... >.<

No choice, bring to a good guitar tech...

 

[KayCee]

Check if the saddle string slot is not worn excessively. Also sometimes the string itself might be problematic, I've encountered a D string which had a buzz that wouldn't go away as it wasn't wound properly!

If the buzz is only on the open strings, most likely it's a nut and saddle problem.

 

[tyzjames]

since you had your guitar refretted, probably need to level out the frets more?

 

[MadWerewolfBoy]

-Action adjustment, no matter how high the action is, the D and G string will buzz!!!

If it's string buzz caused by string hitting the higher frets when vibrating, then a higher action would solve it, if higher action was adjusted by turning the truss rod and it did not help with the buzzing problem, then the buzz is most probably not caused by vibrating string hitting the higher frets.

Is there a loose part rattling somewhere else? like the locking nut or the saddle?

 

[fgl]

the height of your new frets 6100 must be higher than your existing locking nut .

get a set of locking nut shims then re set height trem string height